Saturday, April 3, 2010
Friday, February 12, 2010
The ATF cooler is simple to install given that u have the right tool. The hardest part for me was taking off the original clamp because its very hard to reach. Need to lift the car and take off the lower cover. The taking off the bumper was easy.
Overall a peace of mind when driving hard all the time. Prolong the life of the transmission.
Wednesday, January 13, 2010
The V4X is probably the cheapest standalone that does not break the bank and has more function the piggyback thats almost the same price. This is because other than controlling the fuel and ignition it is also capable of controlling the Toyota VVT-I. Where most piggyback and standalone only offer VTEC control.
Wolf V4X
Normal Price: $2,200.00
Normal Price: $2,200.00
Promotion Price: $1,800.00 (PROMOTION END ON 31ST JAN 2010)
Description:The Wolf V4X is a very cost effective, light-weight and compact engine management system.
Inputs:
Engine Speed
Vehicle Speed
Engine Temperature
Air Temperature
Throttle Position
Internal MAP Sensor (Rated to 30 PSI)
Outputs:
4 Injector Drivers - (Minimum Injector Impedance 0.8 Ohms per output)4 Ignition Outputs
Fuel Pump Control
Boost Control
Stepper Motor Idle Speed Control
PWM Idle Speed Control
2 Switched Low Side Auxiliary Outputs
4 Switched High Side / Low Side Auxiliary Outputs
Note: This kit is a universal (wire-in) kit. You can check out our range of Plugin V4X ECU's to find an ECU that plugs straight into your vehicles original harness. No Wiring!
Normal Price: $2,800.00
Promotion Price: $2,400.00 (PROMOTION END ON 31ST JAN 2010)
Description:
8 Smart, Full sequential Injector outputs, driving 1-32 injectors, including high flow, low impedance injectors down to 0.5ohms per output pin.The V500 injector driver system reports live status of all injector channels including peak and hold reached times, injector current, short, weak and open circuits.
8 Full sequential Ignition outputs, driving 1-8 ignition coil packs in sequential, banked, single, rotary or inverted modes.
Latest 3D graphing, live dashboards and Datalogging software.
Advanced high-detail Fuel, Ignition and Control mapping systems, 2048 points at 125rpm steps with Easy Tuning modes.
Dual Memory system, Power/Economy, Petrol/Gas modes and more.
Control Functions:
16 General Purpose Output (GPO) functions supporting Auxiliary Outputs, with windowed switching
6 MultiController Output (MCO) functions, supporting 3D and 2D multi-axis tables for mapped linear control of any extra outputs desired, including PWM, solenoid position and trim control of internal ECU parameters
GPO and MCO functions can support VTEC/VVT, NOS, Water Spray, Stepper Motor, Emissions Control, Idle Up, Warning Lights, and any other additional devices required.
Wide-Band Air-Fuel-Ratio (Lambda)
Closed Loop Control
Idle Speed Control
Stepper Motor Control
Turbo Boost/Wastegate Control
Turbo Timer support
Shift Light function, dedicated with up to 6 stages and flash point.
Dedicated Inputs:
13 Auxiliary Input pins available as many extra inputs
Camshaft, Crankshaft, Reference and Sync Trigger inputs, Hall Effect, Reluctor and Optical, user selectable
Internal MAP sensor up to 30psi boost (higher with external sensor)
External MAP or MAF Sensor
Throttle Position
Engine Temperature
Lambda/Oxygen Sensor, Dual Channel, Narrow Band or Wideband LSU4
Air Conditioning Request
Vehicle/Wheel Speed
Dedicated Outputs:
15 to 27 Auxiliary Output pins available as extra outputs (unused Injector and Ignition pins can be used)
8 Smart, Full sequential Injector outputs
8 Full sequential Ignition outputs
Fuel Pump
Thermo Fan
Idle Speed Control
Tacho Output
Turbo Timer
Sensor Inputs have full OEM-style diagnostics and error checking on each input, detecting out of range or faulty sensors, correcting them to a safe value, and reporting the fault via a flash-code system. Any errors logged can then be inspected by the Wolf V500 PC Software included.
Runs engines up to 16 cylinders with full rotary engine support and odd cylinder counts allowed.
Internal MAP sensor reads boost pressures up to 30psi.
Supports most existing sensors in the vehicle, saving wiring and installation time.
Latest 32 bit processor running at 40MHz with Dual Time Co-Processors, giving precise sequential delivery of fuel and ignition and supporting all other functions including high speed Datalogging with no performance loss.
Weighs only 500 grams and measures 126mm x 114mm x 39mm.Supplied with wiring harness, quick start guide and searchable installation manual.
8 Full sequential Ignition outputs, driving 1-8 ignition coil packs in sequential, banked, single, rotary or inverted modes.
Latest 3D graphing, live dashboards and Datalogging software.
Advanced high-detail Fuel, Ignition and Control mapping systems, 2048 points at 125rpm steps with Easy Tuning modes.
Dual Memory system, Power/Economy, Petrol/Gas modes and more.
Control Functions:
16 General Purpose Output (GPO) functions supporting Auxiliary Outputs, with windowed switching
6 MultiController Output (MCO) functions, supporting 3D and 2D multi-axis tables for mapped linear control of any extra outputs desired, including PWM, solenoid position and trim control of internal ECU parameters
GPO and MCO functions can support VTEC/VVT, NOS, Water Spray, Stepper Motor, Emissions Control, Idle Up, Warning Lights, and any other additional devices required.
Wide-Band Air-Fuel-Ratio (Lambda)
Closed Loop Control
Idle Speed Control
Stepper Motor Control
Turbo Boost/Wastegate Control
Turbo Timer support
Shift Light function, dedicated with up to 6 stages and flash point.
Dedicated Inputs:
13 Auxiliary Input pins available as many extra inputs
Camshaft, Crankshaft, Reference and Sync Trigger inputs, Hall Effect, Reluctor and Optical, user selectable
Internal MAP sensor up to 30psi boost (higher with external sensor)
External MAP or MAF Sensor
Throttle Position
Engine Temperature
Lambda/Oxygen Sensor, Dual Channel, Narrow Band or Wideband LSU4
Air Conditioning Request
Vehicle/Wheel Speed
Dedicated Outputs:
15 to 27 Auxiliary Output pins available as extra outputs (unused Injector and Ignition pins can be used)
8 Smart, Full sequential Injector outputs
8 Full sequential Ignition outputs
Fuel Pump
Thermo Fan
Idle Speed Control
Tacho Output
Turbo Timer
Sensor Inputs have full OEM-style diagnostics and error checking on each input, detecting out of range or faulty sensors, correcting them to a safe value, and reporting the fault via a flash-code system. Any errors logged can then be inspected by the Wolf V500 PC Software included.
Runs engines up to 16 cylinders with full rotary engine support and odd cylinder counts allowed.
Internal MAP sensor reads boost pressures up to 30psi.
Supports most existing sensors in the vehicle, saving wiring and installation time.
Latest 32 bit processor running at 40MHz with Dual Time Co-Processors, giving precise sequential delivery of fuel and ignition and supporting all other functions including high speed Datalogging with no performance loss.
Weighs only 500 grams and measures 126mm x 114mm x 39mm.Supplied with wiring harness, quick start guide and searchable installation manual.
Also available @ Sen Yeong are Tein(official distributor), OWS lubricants, Motul, Project Mu brake system etc
Thursday, December 17, 2009
When we look @ GT cars, we can see aerodynamic diffusers on the cars. Even the body are widened to accommodate the wider tyres. These aerodynamics helps the cars to corners with great speed which complements the rigid chassis, suspensions and sticky tyres.
This is why call it GT S15 because apart from the already aerodynamic proven Vertex bodykit, the owner also did a full diffuser kit giving it a unique GT look.
Wednesday, December 9, 2009
I removed the rubber intake hose andconnected the MAF adapter directly to the throttle body, unfortunately by doing so my PCV hose will be left exposed and its sucking dirty air directly into the camshaft etc..
I forgot to put it back on for a whole day of driving...
Tomei turbo, HKS camshaft and a lot of bolt-ons parts and controlled by HKS F Con V Pro show how heavy moded this car is. Even the gearbox was swapped with an Evo 8 since the stock Semi-auto transmission cant handle 430+hp.
A mild tune car with 300hp+ suitable for daily driving and extra power when needed. With Evo here and there including the Evo X wheels. Ralli Art bodykit keeps the car looking clean and sporty. The best part is the HKS F Con V Pro to control the engine squeezing out all the power it can produce for all the mods.
Subscribe to:
Posts (Atom)
